Exalt Installation and Management Guide
EX-i Series FDD Digital Microwave Radios
30
202675-005
2011-08-30
Make Connections
It is recommended that one radio at a time be configured, on a bench, before taking the radios to the
field for installation. Terminate the RF connector with a 50-Ohm termination or a fixed attenuator of at
least 20dB (see
Once connected to the radio using Ethernet, log in to the Exalt GUI.
Log In
Use the following steps to log in to the Exalt GUI.
1
Open a browser window.
Microsoft Internet Explorer is the recommended browser. Netscape, Mozilla, and Firefox are also
supported. If there are issues with your browser, please report it to Exalt Customer Care. You may
be required to use a different browser to immediately overcome issues.
2
Type the IP address of the radio in the address bar.
Figure 17 Initiating the browser connection
The following window displays after pressing the Enter key or clicking the Go button in the
browser window.
Figure 18 Browser Login screen
Login Privileges
There are two levels of login privileges:
•
Administrator (admin) – assigned complete permissions to view, edit, and configure
CAUTION!
Do not connect the radios in a back-to-back configuration unless the IP
addresses of the two radios are verified as different from each other.
Note:
The IP address subnet of the accessing computer must match the radio’s IP address
subnet to connect using Ethernet.
Summary of Contents for EX i GigE Series
Page 133: ...202675 005 2011 08 30...
