Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
201872-003
10
2015-10-23
•
System latency (delay)
Use the
ExaltCalc
calculator to determine optimum settings for the above parameters to meet the needs
of your application.
The following generalizations can be made with regards to these factors:
•
The shorter the TDD frame size, the lower the latency
•
The shorter the link distance, the lower the latency, the higher the throughput
•
The longer the TDD frame size, the higher the throughput
•
The higher the bandwidth, the higher the capacity
•
The higher the mode, the higher the capacity
Link Orientation and Synchronization
Link
orientation
refers to the Radio A and Radio B placement in your network. Link
synchronization
refers to using external or internal timing to coordinate multiple links.
For every link, one end of the radio link must be configured as Radio A, while the other end is
configured as Radio B. In single-link systems, it does not matter which end of the system is mounted at
which end of the link, and there is typically no requirement for any link synchronization.
Link orientation and synchronization are more important for networks with site(s) where there is more
than one link of the same type or for sites using the same type of radio that are very close to each
another at one or both ends.
Configure collocated radio terminals for the same link orientation. That is, configure all radios at the
same location as Radio A or Radio B.
Use link synchronization for collocated links. The radios allow the use of an internal synchronization
source or an optional GPS synchronization kit. This synchronization controls the transmitter and
receiver frame timing so that collocated radios are transmitting at the same time and receiving at the
same time. This can substantially reduce the opportunity for self-interference. Without
synchronization, collocated radios may be transmitting and receiving at the same time, incurring near-
end interference.
Note:
Disable all T1/E1 ports if there are no T1/E1 interfaces connected. This shifts all available
throughput to the Ethernet interface.
Note:
If a selected combination of the Link Distance, Frame Size, Bandwidth, and Mode
parameters cannot support all the desired T1 or E1 ports, the ports that cannot be supported are
automatically disabled. Priority is placed on the T1/E1 port number. That is, the first port to be
disabled, if necessary, is the highest port number, such as Port 4. See
for more information.
