Exalt Installation and Management Guide
EX-r Series GigE Digital Microwave Radios
201872-004
95
2016-05-26
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
regulations.
Changes or modifications not expressly approved in writing by Exalt may void the user’s authority to
operate this equipment.
This device must be professionally installed.
To comply with regulations, the output power of this device may need to be adjusted in accordance to
the associated transmission system. See
for details.
The antenna associated with this device shall be mounted in a location that is at least 10.5'/3.2m away
from humans that may be subject to long-term or continuous exposure.
Canada Compliance
The EX-5r GigE models operate under RSS-210 of Industry Canada regulations. Operation is subject
to the following conditions, unless express permission is granted by Industry Canada to operate in a
different manner:
•
External amplifiers cannot be used to boost the power or to overcome transmission system losses,
unless the specific amplifier/cable/antenna combination is expressly authorized by Industry
Canada.
•
Cross-border transmissions are expressly prohibited, except with written permission from both
Industry Canada and the governing body of the neighboring country (FCC for USA)
•
Only parabolic dish antennas or directional flat-panel antennas may be used. No other types of
antennas (omni-directional, yagi, and so on) are authorized. Parabolic dishes of either grid or solid
type are allowed. Maximum gain of each type of antenna allowed is:
–
Parabolic dish: 37.9 dBi (6'/1.8m diameter)
–
Directional flat panel: 28 dBi (~2'/61cm square)
Industry Canada (IC), Canada
This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du
Canada.
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two
conditions:
1
this device may not cause interference, and
2
this device must accept any interference, including interference that may cause undesired
operation of the device.
Antennas Supported in Canada
The EX-r Series GigE radios are designed to operate with the antennas listed in
, which have a
maximum gain of 37.5dBi. Antennas not included in the list or having a gain greater than 37.5dBi are
strictly prohibited for use with this device. The required antenna impedance is 50 Ohms.
