Setup
96
27891EN-900-02 / Edition 02/2017
10.18.
MOUNTING THE SOLVENT DISPENSER FOR
GUIDE LUBRICATION
Allen screwdriver 6 mm
Open-ended spanner 22 mm
NOTE
Destruction of rollers with working widths 85 mm and 170 mm in force mode
(E-models):
Due to low gap widths and high line pressure, we recommend to operate the
machine with a solvent dispenser for guide lubrication in force mode in order
to enhance protection of the rollers against damage.
Fig. 68: Mounting splash guard for inner paneling
1. Mount plastic guides matching the working width.
2. Undo
blue
or
black
screw, respectively, at the central unit.
3. Undo nut at dispenser (
a
) with open-end spanner 22 mm so that the
dispenser can move in its holder (
b
).
4. Push in holder (
b
) and align position.
5. Tighten hexagon socket screw.
6. Align the tube of the dispenser so that the dry run area is wetted.
7. Tighten nut size 22.
8. Close dispenser valve completely and fill dispenser.
9. Open the dispenser valve according to the required amount.
b
a