Setup
93
27891EN-900-02 / Edition 02/2017
10.15.
MOUNTING HOPPER FOR WORKING WIDTH
200 MM
Allen screwdriver 4 mm, 6 mm
NOTE
Roller destruction due to incorrect input of the working width (E-models)
›
In general, program the working width of the used safety device via the
operating unit. Else the line force values [N/mm] will not correspond.
Danger of roller destruction in force mode.
Fig. 65: Mounting hopper for working width 200 mm
1.
Mount plastic guides with „top for shoulder guide, hopper“ (see chapter 10.12
Mounting plastic guides for working width 200 mm).
2. Screw out both securing bolts (
a
) up to the stop.
3. Carefully insert both hopper plates (
b
) into the guide slots of the plastic
guides up to the lower stop.
4. Set protective grid onto the hopper plates.
5. Set hopper safety guard (
c
) into place.
6. Screw in both securing bolts (
a
) with the Allen screwdriver.
c
a
b