Operation
119
27891EN-900-02 / Edition 02/2017
12.7. ROUTINE OPERATIONS
Fig. 99: Display routine operations, numerical view
a Display gap 1
b Gap width [Inc]
c Line pressure [N/mm]
d Settings working width
e Temperature display(s)
f Display gap 2
g Display drive parameters
h Program menu
i Menu DataLog
j Display process data, change
between graphical, schematic
and numeric display
k Settings
›
Set the desired gap values with control dials 1 and 2 (about how to find the
correct gap values see chapter 12.8 Routine operations: Test run with
›
Pressing the corresponding control dial toggles between gap mode and force
mode.
Note:
In the beginning, only operate in gap mode until you master operation in
gap mode securely.
›
Use control dial 3 to set the desired speed. Start with a low speed, e.g. 80 ...
100 rpm.
›
Press start button. Gap widths and speed can be varied during operation.
b
c
d
e
j
k
i
a
f
g
h
i