Understanding OneBlox and OneSystem
| Version 2.15.5 | page
28
C
HAPTER
5 : OneBlox 4312
OneBlox 4312 User Guide
Figure 5-3: Installing the Rack Rails
5.2 - How do I Install the Disk Drives in OneBlox 4312?
5.2.1 - SAS/SATA Drive Installation
These drives are mounted in carriers to simplify their installation and removal from OneBlox. The
carriers also help promote proper airflow for the drives. For this reason, even empty carriers
without hard drives installed must remain in OneBlox.
To remove a Drive Carrier
1.
Push the release button located beside the drive's LEDs.
2.
Swing the handle fully out and use it to pull the drive carrier straight out (see Figure 5-4).
To mount a drive in a Drive Carrier
1.
To add a new hard drive, install the drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
2.
Secure the drive to the carrier with screws, as shown in Figure 5-5.