Chapter 6
IP parameters configuration
6.1. Resets
-
WARNING
-
You should not reset your eWON unless you have been told to do so by someone of our
technical support. The concerned files (differs depending on reset type) are totally lost and
unrecoverable after being formatted.
To press the reset button:
you will need a propelling pencil
(or an unfold paper clip)
to pass through the hole in the front panel.
6.1.1. User Reset
This is the first level and most usual level of reset. It consists in formatting only the « user file »
part of the non-volatile memory. The Tag configuration and the customer web site are part
of the formatted files.
You generate this first level reset by pressing and maintaining the reset button during
approximately 4 seconds after powering the eWON up until the “USER” LED flashes in red 1x
per second.
When this state is reached, release the button and wait approximately 30 secs until the
procedure is completed. The eWON restarts automatically and is ready to communicate.
This type of reset does not modify the communication parameters.
6.1.2. Factory Reset
This second level reset is used only exceptionally because it formats all non volatile
memories and make the eWON returning to its factory defaults. This operation consists in 3
stages:
•
Formatting of all non volatile memories, including all COM parameters and IP
addresses
•
Return to ex-factory configuration (default configuration)
•
Full hardware auto test with result shown by the “USER” LED
You generate this second level reset by pressing and maintaining the reset button during
approximately 20 secs after powering up the eWON until the “USER” LED remains RED
continuously. When this state is reached, release the button and wait approximately during
90 seconds until the procedure is completed.
The procedure finishes with the result of the auto test on the “USER” LED. If the auto test is
completed successfully, then the “USER” LED will blink in RED with a pattern of 200ms ON
and 1,5 sec OFF.
Any other pattern will start with 200ms ON (opening of the pattern) followed by OFF and a
certain number of times 1 sec ON that allows to identify the nature of the detected
problem. Please call the technical support if you are confronted with an error pattern on the
“USER” LED.
Page 24 / 36
eWON 2005CD | IG 001