Machine description – quick overview
Machine control – Operating elements
20
099-005407-EW501
8.2.2022
4.3 Machine control – Operating elements
Figure 4-4
Item Symbol Description
0
1
Functional sequence
> see 4.3.1 chapter
2
Push-button, welding task selection (JOB)
Select the welding task using the welding task list (JOB-LIST) (not applicable for Phoe-
nix Expert). The list can be found inside the protective cap of the wire feed mechanism
and in the appendix to these operating instructions.
3
Display, left
Welding current, material thickness, wire speed, hold values
4
Push-button, parameter selection left/power-saving mode
AMP ----- Welding current
--------- Material thickness
> see 5.3.7 chapter
--------- Wire feed speed
Hold ----- After welding, the values used last are shown from the main program. The
signal light is illuminated.
STBY ---- Press for 2 s to put machine into power-saving mode.
To reactivate, activate one of the operating elements
> see 5.8 chapter
.
5
Display, JOB
Shows the currently selected welding task (JOB number).
6
Welding parameter setting, rotary dial
For setting the welding performance, for selecting the JOB (welding task) and for set-
ting other welding parameters.
