Design and function
MIG/MAG welding
62
099-005504-EW501
20.11.2015
5.10.13 Standard MIG/MAG torch
The MIG welding torch trigger is essentially used to start and stop the welding process.
Operating elements
Functions
Torch trigger
• Start/stop welding
Other functions are also possible by tapping the torch trigger, depending on the machine type
and control configuration- See 5.17 Special parameters (advanced settings) chapter:
• Change over between welding programs (P8).
• Program selection before starting welding (P17).
• Switching between wire feed units in dual operation mode (P10).
5.10.14 MIG/MAG special-torches
Function specifications and more indepth information can be found in the operating manual for
the relevant welding torch!
5.10.14.1 Program- and Up- / down operation
Figure 5-30
Item Symbol
Description
0
1
Welding torch function changeover switch
(special welding torch required)
Changing over programs or JOBs
Infinite adjustment of welding performance.
5.10.14.2 Switching between Push/Pull and intermediate drive
DANGER
Do not carry out any unauthorised repairs or modifications!
To avoid injury and equipment damage, the unit must only be repaired or modified by
specialist, skilled persons!
The warranty becomes null and void in the event of unauthorised interference.
• Appoint only skilled persons for repair work (trained service personnel)!
CAUTION
Test!
Before re-commissioning, it is essential that an "inspection and test during operation"
is carried out conforming to IEC / DIN EN 60974-4 "Arc welding devices - inspection and
testing during operation"!
• For detailed instructions, please see the standard operating instructions for the welding
machine.
The plugs are located directly on the M3.7x printed circuit board.
Plug
Function
on X24
Operation with Push/Pull welding torch (factory setting)
on X23
Operation with intermediate drive
