Design and function
MIG/MAG welding
099-005507-EW501
13.09.2018
37
5.4.4.7 Arc dynamics (choke effect)
This function can be used to adjust the arc between a narrow, hard arc with deep penetration (positive
values) and a wide and soft arc (negative values). In addition, the selected settings are displayed with
signal lights below the rotary knobs.
ENTER
EXIT
3s
Figure 5-21
5.4.4.8 superPuls
In superPuls mode, the program toggles between the main program (PA) and the reduced main program
(PB). This function is e.g. used for thin sheet welding to reduce the heat input in a controlled manner or
for positional welding without the need for weaving.
The welding power can be represented as average value (ex works) or solely as program A value. If the
average value display is activated the signal lights of the main (PA) and reduced main program (PB) are
illuminated simultaneously. The display variants can be toggled using special parameter
P19,
> see 5.10 chapter
.
ENTER
EXIT
3s
Figure 5-22
Display
Setting/selection
Selects superPuls
Switches function on or off.
Switch on
Switching on machine function
Switch off
Switching off machine function
