Design and function
Interfaces
46
099-005366-EW501
31.07.2014
12-pole connection assignments for mechanised welding interface (X2):
Pin
Signalshape
Circuit diagram signal
name
Function
A
NC
B
NC
C/L
Input
Not-Aus
Emergency stop for higher level shut-down of the
power source.
To use this function, jumper 1 must be unplugged on
PCB M320/1 in the welding machine.
Contact open = welding current switched off
D
NC
E
Gasdüsensensor 1
F
NC
G
NC
H
NC
J
NC
K
NC
M
NC
5.14.8 Sensor Voltage
Outside the welding process, there is a voltage of approx. 12 V on the welding torch electrode. If the
electrode comes into contact with the workpiece or the molten pool, the short-circuit produced means that
when using the relevant interface (BUSINT X11/RINT X12), the resultant signal can be used for various
functions (e.g. workpiece search).
Summary of Contents for alpha Q 352 puls MM
