12
CLEANING AND MAINTENANCE
Changing the Drive Belt
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt
appears worn, you will need to replace it.
To remove the drive belt, read the instructions and follow the drawings below:
Ensure the machine is switched off and unplugged.
Step 1: Use a cross head screwdriver to remove the six screws at the base of the
machine – this will release the cover. Make sure to put them safe to one side.
Grasp the old drive belt and remove from the motor shaft. Discard the old drive belt.
Step 2: Loop the new drive belt over the motor shaft. Stretch the other end over the
floor brush in the space provided between the bristles.
Place ends of floor brush down into slots on sides as shown.
Step 3: Turn the floor brush by hand several times in the direction of the motor shaft.
If properly installed, drive belt will align itself on floor brush.
Step 4: Replace the brush cover and six screws.
