EVS XSnano, Configuration Manual

Page: 77 / 198

Sync PC Time to TC
Description Specifies whether the PC time is synchronized with the
timecode, and how often the synchronization takes place.
Values Synchronization: Yes/No
Frequency: by default 'every 00h15' (not editable)
Genlock
Description Specifies the type of genlock signal, the status and the frame
synchronizer mode.
Values Type: 'Blackburst' or 'Tri-Sync' (always 'Blackburst' in SD)
Status: 'OK or Valid' or 'BAD' (defined by the EVS server)
Mode: 'Studio' (no correction of a shifted video signal) or
'Resync' (resynchronization of a shifted video signal)
About Multi-Essence
Introduction
From Multicam 12, the XSnano server can encode, at a time, a record train in two different
codec types, which are called essences. The following essences are available:
Intra
and/or LongGOP (XDCAM) . This process is seamless to the user, who will go on
working as before with the EVS server.
This section provides an overview of the multi-essence feature, and mainly specifies the
rules and restrictions you should take into account when you configure an XSnano server
in multi-essence.
Essence Combinations
The essences can be combined as follows:
• Intra + LongGOP
• Intra only
• LongGOP only
General Rules
• You will only see one record train per record channel and one clip per LSMID even if
the record trains and clips exist in several essences on the EVS server.
• A single clip shall be identical in all available essences.
CONFIGURATION MANUAL XSnano Server 12.02
3. Multicam Configuration 67