EVS XSnano, Configuration Manual, Page: 15 / 198

• Define the configuration parameters for each configuration line you will need.
In this step, you will define, among others, the channel configuration for the selected
configuration line, as well as audio and video parameters for the EVS server.
For more information, see section "Multicam Configuration" on page 42.
When Starting the EVS Server After Initial Configuration
After the initial configuration, you will select a configuration line and press ENTER to run
the server in this configuration. See section "Launching a Configuration" on page 12. As
soon as the EVS server is launched in a configuration, it starts the loop recording process.
1.4. Accessing the Web-Based Interface
Prerequisite
When the EVS server is started, you can access the web-based interface of the Multicam
Setup application for that EVS server from any computer that is on the same network
range as the EVS server. You can use any browser to open the web-based interface.
Procedure
To be able to open the web-based interface in a browser, you need to know the IP address
of the PC LAN of the EVS server. See section "Setting the Server LAN PC Address" on
page 25 for more information.
In your browser, enter the following URL: http://xxx.xxx.xxx.xxx/cfgweb/ where the
crosses correspond to the PC LAN IP address of the EVS server you want to access.
CONFIGURATION MANUAL XSnano Server 12.02
1. Introduction 5