EVS Synapse UXU500, Installation And Operation Manual, Page: 36 / 72

5.11. LUT Control
Setting Description
Lut-Prst_Act With this setting you can manually change the currently active LUT settings. Can
be any preset between 1 and 16. By default it is set to 1. All menu settings that are
preceded with a ‘# ‘-prefix under the ‘LUT CONTROL’ header are part of the preset.
Lut-Prst_Edit Here you can select which of the 16 selectable LUT setting presets you want to
edit. Changing this will not change the active preset, unless the currently active
preset is the same you are going to edit. All menu settings that are preceded with a
‘# ‘-prefix under the ‘LUT CONTROL’ header are part of the preset.
Split-Screen
(UXU500-510
only)
This setting turns the split screen On or Off, showing a horizontal split video. The
left side shows the input video through the LUT and matrix conversions. The right
side shows the input video transparent. The position of the split can be set with the
H-Split setting. Default is Off.
H-Split
(UXU500-510
only)
When the Split-Screen setting is set to On , this setting controls the horizontal split
position of the video. The setting uses percentages from 0% to 100%, where 0%
shows the full right side and 100% shows the full left side. The left side shows the
input video through the LUT and matrix conversions. The right side shows the input
video transparent. Default is 50%.
SMPTE ST 352 Video Payload Identifier
The SMPTE ST 352 Video Payload Identifier, also known as VPID, is transported within the ancillary data
of an SDI stream. The ancillary packet is placed in the HANC space. This packet contains 4 bytes of
data.
There are two versions of the standard. The first was published in 2011 and the second in 2013. The
revision can be seen within the 4 bytes.
When the UXU500-510 is not processing the incoming VPID packets, they will be passed transparently.
When it generates the packets, the UXU500-510 will output VPID packets using the 2013 standard.
#S352_Insert S352_Insert enables the Video Payload Identifier insertion in the HANC space. It
enables the user to insert or passthrough (On) the S352 Dynamic range and
colorspace payload. When this menu item is set to On (default), it will generate a
SMPTE ST352-2013 packet and overwrite the existing one (for both Luminance
and Chrominance).When it is set to Off, it will pass the packet to the output as-is
(only on Luminance).In HD 1080i for ATC-LTC transparency, the user may switch it
Off to pass the ATC-LTC HANC packet on line 10.
#All_Transparent
(UXU500-510
only)
When this is set to On , the RGB gain and the whole LUT system will be transparent,
i.e. no conversion will be applied. Settings are On or Off (default).
28 | November 2021 | Issue 1.1.A