EVS Synapse GED100, Manual

Page: 53 / 74

7. Events Menu
Introduction
An event is a special message that is generated on the card asynchronously. This means that it is not the
response to a request to the card, but a spontaneous message.
What is the Goal of an Event?
The goal of events is to inform the environment about a changing condition on the card. A message may
be broadcast to mark the change in status. The message is volatile and cannot be retrieved from the
system after it has been broadcast. There are several means by which the message can be filtered.
The events reported by the GED100 card are as follows:
Menu Item Description
Announcements Announcements is not an event. This item is only used for switching the
announcement of status changes on/off. 0=off, other =on
Input1 ~ Input2 Input1 to Input2 can be selected between 0 .. 255. 0= no event, 1..255 is the
priority setting.
CRC-Status1 CRC-status1 can be selected between 0 .. 255. 0= no event, 1..255 is the priority
setting.
CRC-Status2 CRC-status2 can be selected between 0 .. 255. 0= no event, 1..255 is the priority
setting.
Lock-Status Lock status can be selected between 0 .. 255. 0= no event, 1..255 is the priority
setting.
Ref-Status Reference can be selected between 0 .. 255. 0= no event, 1..255 is the priority
setting.
DolbyLoss-Status Reference can be selected between 0 .. 255. 0= no event, 1..255 is the priority
setting.
INSTALLATION AND OPERATION MANUAL
Synapse GED100 | 7. Events Menu | 45