EVS Multicam LSM, Operation Manual, Page: 133 / 242

How to Add an Audio Split
When you perform an audio split, you specify the TC for the beginning or the end of the
audio transition. In this case, you can choose whether you perform an audio delay or
advance.
To add an audio split, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press to highlight V Base ( SHIFT+A ).
4. Press to highlight A Split ( D ).
5. Jog to the point where you want to set your transition.
6. Do one of the following:
◦ Mark an OUT point if you do an audio delay.
◦ Mark an IN point if you do an audio advance.
The value entered will be present on the PRV screen when the clip is next to play in a
playlist.
Note
If the IN or OUT point is defined two clips before or after the current clip (or even
beyond), you will be asked to convert the playlist to a timeline.
5.8.7. A Base Editing in Split Audio
Description
In an A Base edit, you delay or advance the beginning of the video transition compared to
the audio transition of the clip. ABase Editing is only available on the Remote Panel.
Note
When editing using the Video IN/OUT as the reference point (V Base), the video
will be the top line on the OSD display. When editing using the audio IN/OUT as
the reference point (A Base), the audio will be the top line on the OSD display.
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 121