EVS Multicam LSM, Operation Manual, Page: 128 / 242

5.8.5. Extending a Transition in Split Audio
Introduction
Whenever you perform a video or audio split on the Remote Panel, the transition originally
set is changed, which means extended on either or both sides of the transition boundaries.
In the Operational Setup menu, use the Extend split transition parameter (p.3.2 F3) to set
the default mode for extending transition effects, this means you specify where the effect
is extended.
Transition Modes
The following table summarizes the various transition modes:
Criteria Description
Center (on) Cut The transition is extended equally in both directions. This is the
default value.
End (on) Cut The transition is extended to the left, so that the end of the transition
is not changed.
Start (on) Cut The transition is extended to the right, so that the start of the
transition is not changed.
Ask Asks the operator to choose one of the 3 options above each time he
edits a transition.
Possible Cases
You can build different types of playlists depending on:
• the transition mode in video or audio split
• the transition duration
The following schemas show, for each transition mode, a playlist with:
• the same video and audio transitions (no audio or video split) on playlists 10, 13 and 16
• an extended audio transition (V Base edit) on playlists 11, 14 and 17
• an extended video transition (A Base edit) on playlists 12, 15 and 18
116 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A - May 2014