Evoqua WALLACE & TIERNAN SFC, Original Instruction Manual

Page: 202 / 288

202
WT.050.590.000.DE.IM.0719
Operation
SFC
6.
Calibration aids of the flow rate
module DEPOLOX
®
5,
DEPOLOX
®
Pool, VariaSens
Two clips are installed in the housing cover. These clips can be
inserted into the rear panel of the housing.
The clip (A) for the sensor will be inserted into the upper catch.
When the electrodes are calibrated in the beaker with the
calibration solution, the second clip (B) will be inserted into the
middle catch (left figure). The lower clip position is provided for
calibrating with the calibration solution bag (right figure).
Picture 3 Fastening clips
A Upper clip
B Lower clip
6.4.1 Temperature calibration
1 Starting from the basic display in the main menu select the
"Calibration" menu.
2 Select the "Temperature" menu item
The window "Calib. temperature" appear on the graphic display.
3 Select the "Cal. temperature" parameter.
4 Perform comparative temperature measurement.
5 Open the menu with the „Enter“ key and enter the ascertained
value with the arrow keys.
6 Save the value by pressing the „Enter“ key.
This concludes the temperature calibration.
Please note
It is possible to select °C or °F in the „Temp. unit“ menu. The
required temperature input can be selected or switched off in the
„Temp. sensor“ menu.
A
B
B
A