120
WT.050.580.000.DE.IM.0714
Operation
MFC
5.
5.2
Notes on Operation
During operation observe the following points:
•
Check your entry and modifications before exiting the menu.
•
Only press the keys with your fingers, never with hard or
pointed objects such as pencils, etc. This could damage the
sealed keypad.
Password
The system runs with up to two passwords to ensure protection
against unauthorised or inadvertent incorrect operation:
•
The system password permits full access to all setting options.
•
The calibration password only permits access to the
calibration menu and the display of the menus.
Each password comprises a four-digit number combination.
Please note
The password is not set at the works (four zeros).
A calibration password can only be set if a system password has
been set.
If the password protection was not activated with the "LOCK"
softkey after entry/calibration, the system is automatically locked
one hour later.
The password can be changed after correct entry of the existing
password.
Summary of Contents for WALLACE & TIERNAN MFC
