Evolveo Ringo DB2, Manual, Page: 39 / 79

39
9. Use the outdoor doorbell to scan the QR code
displayed in the application in the distance of 15 to
20 cm until you hear a beep. Press the “Beep
Heard” button.
10. Pairing is finished as soon as you hear a beep. Now
you can rename your device (pencil symbol). Then,
press “Finish” in the top right corner. Your device is
successfully paired.
!!! IMPORTANT !!! The application is continuously
updated and developed; individual steps may differ after
updates. In case of any difficulties during the process,
we recommend that you contact the service center.
Pairing with Socket Doorbell
Ringing, except for notification activation in the phone,
activates the doorbell for standard household
notification.
EVOLVEO Ringo DB2 and the doorbell are
interconnected via 443 MHz (not Wi - Fi). To pair, we
recommend complying with the distance of up to 10
metres to get the best possible functiona lity.
Every obstacle, wall or other interference source in the
surroundings, can decrease the signal strength. In such
cases, move the doorbell closer or to another position.
1. Plug the bell into an active outlet. The doorbell rings
and starts to blink.
2. Repe atedly press the volume button and select the
required doorbell volume. Five options are
available, including Silent (only blinking).
3. You can leave the initial tone unchanged (move to
Step 4), or repeatedly press the melody button to
listen to all available options.
4. After selecting the melody, press and hold the
volume button until the LED indication illuminates.
5. Press the ringing button on the video doorbell
within 5 seconds.
The units are paired now.
The volume can be edited any time without re -pairing.
Any melody change will show only after repeated
pairing.