6-2
Press numeric keys 0-9 to select a new MIDI controller. You can also use
the +/- switches to increase or
decrease the value of the number.
Note: * If you do nothing for 5 seconds, the LED will return to show the
current PROGRAM CHANGE number.
* If the number you press is not in the range of defined numbers, the previous number will be retained.
* When you assign 120 or 121 as the MIDI controller for the WHEEL,
you
should
move
the
MODULATION Wheel to the mid-value then
return it to the minimum value to send a relative MIDI message.
7.
TRANSPOSE
This function allows you to shift the pitch of the unit in semitones. You can transpose the pitch by 24 half steps (12 up, 12
down).
7-1
Press the X’POSER switch. The LED shows the current TRANSPOSE value.
7-2
Press the “+” or “-” switch to change the TRANSPOSE value. Each time
you press + or -, the keyboard is
transposed an additional half step.
* Pressing the + and - switches simultaneously resets the pitch to the default value.
Note: Turning the power off always resets the shifted pitch to the default value.
8. OCTAVE
CHANGE
This function allows you to shift the pitch up to three octaves higher or two lower.
8-1
Press the OCTAVE UP or DOWN to change the octave range. The LED shows the new OCTAVE value.
* Press OCTAVE UP and DOWN switches simultaneously to reset the pitch to the default value.
Note: if the UP or DOWN switch is not pressed for 5 seconds, the LED will return to show the PROGRAM CHANGE
number.
9.
Sending a PROGRAM CHANGE number
Using the PROGRAM switch and the numeric keys, you can send any MIDI PROGRAM CHANGE from 0-127.
9-1
Press the PROGRAM switch. The LED starts to flash showing the
current PROGRAM number.
9-2
Press the numeric keys to alter the PROGRAM CHANGE number. You can also use the “+” or “-” keys to
change the value.
Note: * if you don’t do anything for 5 seconds the LED stops flashing and shows the current PROGRAM CHANGE
number.
* if the number you press is larger than 127, it will return to the previous
PROGRAM CHANGE number.
10.
Sending BANK MSB and LSB message
You can send any value of MSB or LSB from 0-127.
10-1
Press the CHANNEL and PROGRAM switches simultaneously. The LED starts to flash showing the current value
of the LSB. Press the
numeric keys to change the LSB value. You can also use the “+” or “-”
switches to change
the value.
10-2
Press the PROGRAM and MEMORY switches simultaneously. The LED
starts to flash showing the current
value of the MSB. Press numeric keys
to change the MSB value. You can also use the “+” or “-” switches to change
the value.
Note: * if you don’t do anything for 5 seconds the LED stops flashing and shows the current PROGRAM CHANGE
number.
* if the number you input is over 127, it will return to the previous LSB
or MSB value.