Chapter 2 Installation
CPC-1817CLD5NA
- 9 -
Jumper Setting
1.
JCC1: Clear/Keep CMOS Setting
CMOS is powered by the button battery on board. Clearing CMOS will restore
original settings (factory default). The steps are listed as follows: (1) Turn off the
computer and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on
the computer; (4) Follow the prompt on screen to enter BIOS setup when booting the
computer, reload optimized defaults; (5) Save and exit. Please set as follows:
Setup
Function
1-2 Open
Normal (Default)
JCC1
1-2 Short
Clear the contents of CMOS and all BIOS settings
will restore to factory default values.
2.
JLCD1: Select LCD Operating Voltage (Pitch: 2.0mm)
Setup
Function
1-2 Short
+3.3V (Default)
JLCD1
2-3 Short
+5V
3.
JCF1: Select CF Card Voltage (Pitch: 2.0mm)
Setup
Function
1-2 Short
+3.3V
JCF1
2-3 Short
+5V (Default)
4.
SW1 and SW2: Set CompactPCI Bridge Mode
SW1 and SW2 are used to set mode for CompactPCI bridge; please set as follows:
Summary of Contents for CPC-1817CLD5NA
