Evinrude E-Tec 40 HP, Service Manual, Page: 67 / 426

65
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
4
Occurred Service Codes (Faults)
Service codes are saved if an abnormal condition
occurs while the outboard is running.
The
Occurred Faults
scree n of the diagnostics
software shows the code number, the number of
times the event occurred, and operating hours of
first and last occurrences.
Active Faults
An a ctive fau lt is a service code t hat currently
exists. Active faults become occurred faults only if
the outboard is running.
Historical Faults
The
Historical Faults
screen keeps a history of all
previously saved code s, including cod e number,
the number of times the event occurred, and oper-
ating hours of the last occurrence.
Historical faults cannot be erased.
Static Tests
Static Tests allow dia gnostic testing o f system
components while the outboard is NOT running.
Ignition Test
Use the diagnostics software to test each ig nition
circuit. Refer to
Static Ignition Test
on p. 81.
Fuel Test
Use the diagnostics sof tware t o te st each fue l
injector circuit. Refer to
Fuel Injector Static Test
on p. 84.
Oil Injector
Use the diagnostics software to test the oil injec-
tion pu mp circuit. Refer to
OILING SYSTEM
TESTS
on p. 166.
Fuel Pump
Use the diagnostics software to test the fuel pump
circuit. Refer to
Fuel Pump Static Test
on p. 84.
Water Injector
This test activat es the exhaust water valve sole-
noid (60 - 65 HP). Refer to
Exhaust Water Valve
Static Test
on p. 86.
Occurred Faults Review Screen
008584
Active Faults Review Screen
008585
Static Tests Screen
008569A