Evinrude E-TEC 200, Service Manual

Page: 25 / 416

23
ROUTINE SERVICE
OUTBOARD RIGGING CONNECTIONS
2
For an I-Command oil level display, an accessory
CANbus oil level sender must be installed in the
oil tank. Connect the sender to the
I-Command
network. Refer to the I-Command Digital Net-
work Guide .
Use Evinrude Diagnostics software to adjust net-
work settings in the EMM . From the Settings
screen, select Engine Options .
ICON Network Connections
If the outboard is equipped for an Evinrude ICON
control system, connect the outboard to the net-
work as follows.
Refer to the ICON Remote Control System
Installation Guide .
Connect the buss cable from the rear network hub
to the outboard’s network harness.
IMPORTANT:
Do not force connectors or lock-
ing rings. Properly aligned connectors assemble
easily.
Do not use Electrical Grease on ICON buss cable
connectors.
To assemble the connectors:
•
Use the large tabs and small tabs to carefully
align buss cable connectors.
•
Carefully align pins and sockets of connectors.
Do NOT force connectors together.
•
Tighten locking rings of buss connectors finger
tight. Do NOT use locking rings to force connec-
tors together.
Do not rotate connectors until they align. This
could result in a mismatched connection. It is pos-
sible for each pin to enter a socket even if the tabs
are misaligned. Look at the tabs to ensure con-
nector alignment prior to making the connection.
Engine Monitor information is distributed to an
ICON or I-Command network through the ICON
gateway module. Refer to the I-Command Digital
Network Guide .
The ICON Harness and Relay Kit, P/N 765296,
must be used to provide power to boat accesso-
ries that require switched B+. This kit is used in
place of connecting accessories to the “A” termi-
nal of the key switch. Accessories connected to
the accessory power relay should not exceed 7
amps.
Do not connect boat accessories to
the key switch of an ICON system. Connecting
accessories to the key switch can cause low
Engine Options Screen 008013
1. ICON network connector 008001
1
1. Large tabs
2. Small tabs
007883
1
2
NOTICE