Evinrude E-TEC 200, Service Manual, Page: 182 / 416

180
OILING SYSTEM
OIL COMPONENT SERVICING
Install oil pump on bracket with clamp and retain-
ing screw. Tighten to a torque of 24 to 36 in. lbs. (3
to 4 N·m).
Reconnect the electrical connector.
IMPORTANT:
Use oil primer bulb to purge air
from oil supply hose before reconnecting hose to
oil pump.
Reconnect oil supply hose to the inlet fitting of oil
pump. Fasten with
Oetiker clamp.
Make sure oiling system is primed. Check oil flow
through oil distribution hoses. Check oil system
operation and routing of oil hoses. Refer to
OIL
SUPPLY PRIMING on p. 170.
Run the outboard and check for leaks.
Repair any oil leaks and any kinked or misrouted
hoses.
Rear Oil Pump
Removal
Disconnect the battery cables at the battery.
Remove engine cover.
Remove the oil supply hose from the fitting (inlet)
of the oil pump.
Disconnect the electrical connector.
IMPORTANT:
Note oil distribution hose rout-
ings before proceeding with disassembly.
Remove oil distribution hoses from the crankcase
fittings.
Remove two mounting bracket screws.
Remove the oil injection pump assembly.
IMPORTANT:
The rear oil pump and manifold is
an assembly and cannot be serviced as individual
components.
1. Clamp 004220
1. Oil supply hose
2. Oetiker clamp
005519
1
2
1
1. Fitting (inlet)
2. Mounting bracket screws
008444
2
1