216
POWERHEAD
POWERHEAD ASSEMBLY
the connecting rod. Align bearings with Wrist Pin
Bearing Tool, P/N 336660.
Place the two wrist pin thrust washers on the tool
with flat side of the washers facing out.
Oil the wrist pin bore and wrist pin. Place connect-
ing rod, with bearings, washers, and tool, into the
piston with the alignment dots facing the top of the
piston.
Install wrist pin through piston and connecting rod,
pushing bearing tool out through the piston.
Use Wrist Pin Cone, P/N 318600, and Driver,
P/N 318599, to install new wrist pin retaining rings
in each wrist pin hole. Gap of retaining ring faces
up, away from notch in piston.
Installing Pistons
When all pistons and connecting rods are assem-
bled, install piston ring sets. Be sure rings are
installed in the cylinder used to test ring end gap.
Refer to
1.
28 needle bearings
2.
Wrist pin bearing tool
24903
1.
Wrist pin thrust washers
DR3480
24902
002057
2
1
1
002058
1.
Gap of retaining ring
2.
Notch in piston
002050
2
1
Summary of Contents for E75DPLSCB
