E2408DF
Rev 27.05.2021
Installation and connections
Unscrew four lid screws and detach the lid from the detector.
Fix the detector on a wall by screws, using cross-shaped mounting lugs supplied with the
instrument (see dimensional drawings below).
To connect the device with measurement point, use the hoses of appropriate diameter (4
or 6 mm) and length. Put one end of the hose on the fitting in the bottom part of the device
and fix the other end in the selected measurement area. The port marked with + (plus)
should be connected with the area of higher pressure (e.g. before air filter), the one marked
with - (minus) should be connected to the lower pressure area (e.g. behind air filter).
NB! The connecting hoses should not be squeezed or folded.
The connection diagram of the device is shown below.
5
