Evidence Cross-8/HPoE-10G, User Manual

Page: 168 / 321


Compatibility :
Compatibility is maintained by hosts and routers taking appropriate actions depending on
the versions of IGMP operating on hosts and routers within a network. The allowed
selection is IGMP-Auto, Forced IGMPv1, Forced IGMPv2 , default compatibility value is
IGMP-Auto.

RV :
Robustness Variable. The Robustness Variable allows tuning for the expected packet loss on
a network. The allowed range is 1 to 255; default robustness variable value is 2.

QI(sec) :
Query Interval. The Query Interval is the interval between General Queries sent by the
Querier. The allowed range is 1 to 31744 seconds; default query interval is 125 seconds.

QRI(0.1sec) :
Query Response Interval. The Max Response Time used to calculate the Max Resp Code
inserted into the periodic General Queries. The allowed range is 0 to 31744 in tenths of
seconds; default query response interval is 100 in tenths of seconds (10 seconds).

LLQI (LMQI for IGMP) :
Last Member Query Interval. The Last Member Query Time is the time value represented by
the Last Member Query Interval, multiplied by the Last Member Query Count. The allowed
range is 0 to 31744 in tenths of seconds; default last member query interval is 10 in tenths
of seconds (1 second).

URI(sec) :
Unsolicited Report Interval. The Unsolicited Report Interval is the time between repetitions
of a host's initial report of membership in a group. The allowed range is 0 to 31744
seconds, default unsolicited report interval is 1 second. .
Buttons

Apply :
Click to save changes.

Reset :
Click to undo any changes made locally and revert to previously saved values.
9-2.3 Status
The section describes when you complete the MLD Snooping and how to display the MLD
Snooping Status and detail information. It will help you to find out the detail information of
MLD Snooping status.
Web Interface
To display the MLD Snooping Status in the web interface:
1. Click Multicast, MLD Snooping and Status.
2. If you want to auto-refresh the information then you need to evoke the “Auto-refresh”
3. Click “Refresh” to refresh an entry of the MLD Snooping Status Information.