Evidence Cross-8/HPoE-10G, User Manual

Page: 134 / 321


Action Parameters :
CoS Class of Service : (0-7) or 'Default'.
DPL Drop Precedence Level : (0-3) or 'Default'.
DSCP DSCP : (0-63, BE, CS1-CS7, EF or AF11-AF43) or 'Default'.
PCP PCP : (0-7) or 'Default'. Note: PCP and DEI cannot be set individually.
DEI DEI : (0-1) or 'Default'.
Policy ACL Policy number: (0-127) or 'Default' (empty field).
'Default' means that the default classified value is not modified by this QCE.
Buttons

Apply :
Click to save changes.

Reset :
Click to undo any changes made locally and revert to previously saved values.

Cancel :
Return to the previous page without saving the configuration change.
6-8.2 Status
The section will let you know how to configure and shows the QCL status
by different QCL users. Each row describes the
QCE that is defined. It is a conflict if a specific
QCE is not applied to the hardware due to hardware limitations. The maximum number of
QCEs is 256 on each switch.
Web Interface
To display the QoS Control List Status in the web interface:
1. Click Quality of Service, QoS Contol List and Status.
2. If you want to auto-refresh the information then you need to evoke the “Auto-refresh”.
3. Scroll to select the combined, static, Voice VLAN and conflict.
4. To click the “Refresh” to refresh an entry of the MVR Statistics Information.
Figure 6-8.2: The QoS Control List Status
Parameter description:

User :
Indicates the QCL user.

QCE :