15
The first ski has been installed. Please refer to instructions 9 – 12 for the second ski installation.
8.
Place the second ski in front of driver’s side front tire, with the proper adjustments made as
shown in section B. Place strapping system to the outside of the ski and vehicle.
9.
Drive vehicle front tire into saddle of ski until tire pushes against front cross plate. Do Not
put vehicle in 4WD.
10.
Once vehicle is put in Park, repeat steps 3 – 8.
11.
Skis are ready for use.
Warning:
Never put a vehicle in 4WD when the SnoCobra ski system has been installed.
Removal
Instructions for removing the SnoCobra ski system.
1.
Make sure vehicle is stopped and in the Park position, on snow or ice, and is on level ground.
2.
Both skis should be taken off at the same time. This prevents one ski from going in reverse that
might cause damage to the ski.
3.
Remove the locking pin from the handle on both skis.
4.
Grab onto the cam lever arm and pull it up and towards the front tire. (Both skis)
5.
When the cam lever releases pressure take out the cam pin with the strap from the hook on the
cam lever. (Both skis)
6.
Lay the straps aside and away from behind the skis and away from the vehicle.
7.
Put the vehicle in reverse and back out of the skis.
8.
Removal complete.
Warning:
Do not put the vehicle into 4WD after the SnoCobra Ski System has been removed. The
front wheels turn at a different speed than the rear tracks. This may cause damage to the vehicle and
personal injury.
