IXG CloudBridge
Internet Exchange Gateway Server
Page - 26
Revision 1.0
best operation, the number of unrecovered packets should always be 0. If this is not the case, verify the
configuration settings between the TX and RX sides and check the Bitrate at both ends (Transmit status
(TX), Network Status (RX)). If the bitrate and all configurations match and there is still data loss
(unrecovered), the user may increase the Target Latency number. This will delay the time process of the
RX side card (Please note: This setting will reduce the number of unrecovered data packets but will also
add latency between TX and RX side).
Figure
4-20 : WebEASY
®
- Internet Input IP Stream
