HD9690 Series HDTV Graticule Generator Manual
DESKTOP CONTROL PANEL OPERATION
Revision 1.5
Page 4-5
Mask apert = prod
clean
Box % apert= prod
clean
Obj blink = short
long
none
Ln disp =
int rel int abs
Feedback =
aspect
pos
Force centre yes
no
OSD Timer = Off
2 secs
5 secs
10 secs 30 secs 1 min
On
OSD Posn =
Top l
Top r
Bot l
Bot r
center
Safe Area = 2046
RP218
Figure 4-2: Overview of the HD9690 Setup Menu
Mask apert = prod
clean
Box % apert= prod
clean
Obj blink = short
long
none
Ln disp =
int rel int abs
Feedback =
aspect
pos
Force centre yes
no
OSD Timer = off
2 secs
5 secs
10 secs 30 secs 1 min
On
OSD Posn =
top l
top r
bot l
bot r
center
Safe Area = 2046
RP218
Vid Type =
Auto
444 HD
422 HD
444 Mode =
ycbcr
rgb
fsfull
fsnorm
Figure 4-3: Overview of the HD9690-444 Setup Menu
To enter the front panel programming menu, press the
SETUP
key. Pressing the
SETUP
key again allows
you to move vertically down the
Setup
menu tree. You can also use the left shaft encoder know to move
vertically up and down the
Setup
menu tree. The menu item is shown on the left of the front panel display
and the current value for that menu item is shown on the right. Turn the right shaft encoder knob to reveal
the choices for the current menu item. When you have selected the desired sub menu choice press the
SETUP
key to save your choice and advance to the next menu item.
The menu choice that is shown for an item when you press the SETUP key or turn
the left shaft encoder knob will be saved as the new value for that menu item. If
you do not wish to save a new value press the ESC key to exit the SETUP menu.
When you have made all the desired changes, press the
ESC
key to return to the normal display mode.
After a 30-second timeout, the Graticule Generator exits from the
SETUP
menu automatically.
Each of the menu items is described in the sections below, with an explanation of what each choice does.
When you make a change to one of the SETUP parameters you will need to press
the SETUP button or turn the left shaft encoder knob to save the change.
4.2.1. Choosing the Raster limits for the Mask Aspect Ratio and Size Calculation
Mask apert =
prod
clean
