7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
Page - 22
Revision 1.0
Input Audio Proc Control
Enable Audio Proc:
If this is disabled, Audio will follow the embedded audio. If this parameter is
enabled, it allows the user to select which incoming embedded audio channel goes to which Encoder
source channel. Effectively enabling or disabling an audio router at the source of the encoder.
Encoder Audio Source Select:
The drop down menu allows the user to select any embedded audio
channel 1-16 or Mute. When Audio Proc is enabled the respected input channel will be routed to the
Encoder audio source channel as defined by the user.
4.7.
ENCODERS CONTROL TAB
Figure
4-10 : WebEASY
®
– Encoders Control Tab - Part 1
Output Configuration
IP Address:
This parameter allows the user to select a streaming output IP address for the Encoder.
Can be a Multicast or Unicast address.
UDP Port Number:
This parameter allows the user to select the destination UDP port number of the
streaming output.
TTL:
This parameter allows the user to set the TTL (Time To Live) field of the output IP packets.
