evertz 7881TSM-IP, User Manual

Page: 39 / 64

7881TSM-IP
User Manual
Version 1.0
Page - 29
6. TSM GENERAL CONFIGURATIONS
In this section, TSM general configurations can be accessed by expanding the hardware tab in the navigation
tree. Afterwards, the appropriate IP address needs to be expanded as well. Right-click the “TSM General” and
select “View Configuration” or by double-clicking. Finally, select the desired tab from the pop-up window that will
appear on the right.
When making any changes to the parameters/settings, the apply key must be pressed for them to take effect.
Also, the refresh key (or auto-refresh)
may also need to be pressed to see the changes. If the changes
are still not applied, please look at the parameters/settings again or the unit may need power cycle.
GENERAL
The Configurations for all each transport stream can be made here. To add a transport stream, simply enter the
required information. The Ethernet port must remain on Data 1 (Refer to section 5.2 for more details). The Status
will become green (“ACTIVE”) if the stream is connected.
The columns are as followed:
•
Input : Displays the index number of each IP port.
•
Status : Shows if the connected stream is active.
• IP : Control to set the source IP address of each IP input
•
Port : Control o set the transport protocol port of each IP
• Ethernet Port : Control to select the DATA for each IP input.
•
Enable
: To turn the port on/off.
•
Bitrate : Displays the bitrate value (Mbit/s) of the monitored transport stream.
• Configuration : Opens the full settings of each IP input.
Figure 6-1 - VistaLINK PRO General Tab