7800R4X4-RF Switch Series
4X4 RF Router, Software Expandable to 8x16
Page 14
Revision 1.0
4.3.1. Router
Max Inputs:
This field shows the maximum number of available inputs supported by the current
configuration. Configuration is based on the cross point card type currently inserted in the frame.
Max Outputs:
This field shows the maximum number of available outputs supported by the current
configuration. Configuration is based on the cross point card type currently inserted in the frame.
Serial number:
This field shows the serial number of router board 7800R4x4-RF.
Board revision:
This field shows the board revision of router board 7800R4x4-RF.
Factory Restore:
This field allows the user to revert back to factory settings.
4.3.2. Inputs
Squelch Enable:
Set to enable turning off input when power level after gain falls below the squelch
threshold.
Squelch Threshold:
If the input level falls below the Squelch Threshold set point, the input will be
turned off or squelched.
RF Upper Threshold:
This slide bar is the upper RF input power level thresholds for SNMP alarms.
The router will send an SNMP trap if the input level is above the upper set threshold.
RF Lower Threshold:
This slide bar is the lower RF input power level thresholds for SNMP alarms.
The router will send an SNMP trap if the input level drops below the set lower threshold.
4.3.3. Outputs
Enable:
Set output to be disable or enable for routing. Locked output port will not be rerouted.
Lock:
Set output port to be locked. Locked port can no longer change source configuration.
