7780M4-ASI / 7780D4-ASI
Quad ASI TDM-Mux/Demux
Revision 1.0
Page 17
7.3.1. SDI
Monitor
•
SDI Input Standard:
This field displays the detected SDI input standard.
•
SDI TDM Use Vanc:
This field displays the status of the SDI TDM Use Vanc control. The
options for this parameter are ON and OFF.
•
SDI TDM Use Hanc:
This field displays the status of the SDI TDM Use Hanc. The options for
this parameter are ON and OFF.
•
SDI Bypass:
This field displays whether the SDI Bypass is on or off. If it is on, “Bypass” will
be displayed in the field.
7.3.2. SDI
Control
Set SDI Bypass:
The
Set SDI Bypass
drop down menu enables the user to select the SDI Bypass
mode.
•
In
ON
mode the module will operate like a DA where any stream present at the SDI input will
be distributed to all four ASI outputs.
•
In
OFF
mode the SDI input will not be distributed to any of the ASI outputs, the module will only
operate as a demultiplexer.
•
In
Auto
mode if the content present at the SDI input is a valid SDI video, the signal will be
distributed to all four ASI outputs, however if the signal contains TDM content the module will
operate as a demultiplexer.
7.4. GENERAL
The
General
tab permits the user to set a password to protect the control and display monitored
aspects of the board.
Figure 7-3: General – 7780D4-ASI
