7780M4-ASI / 7780D4-ASI
Quad ASI TDM-Mux/Demux
Page 14
Revision 1.0
6.5. FAULTS
The
Fault
tab allows custom configuration of the traps and displays the trap status. Use the auto-
refresh option in VLPro to see the status dynamically updating. In order to enable a trap simply click
on the check box associated with the trap you wish to enable.
Figure 6-4: Faults – 7780M4-ASI
6.5.1. ASI Trap Enable / ASI Trap Status
The
ASI Trap Enable
section allows the user to set which
ASI Trap Enable
controls are enabled. The
ASI Trap Status
allows the user to monitor the status of the faults.
•
ASI Output 1/2/3/4:
This status indicator will remain red unless a valid ASI output is present.
•
ASI Input Bandwidth 1/2/3/4:
This trap status will change to red if the ASI input bandwidth
exceeds the limit set by the user.
•
Input 1/2/3/4 Continuity Count Error:
This trap status will change to red every time the
continuity count counter is incremented indicating a missing or lost packet.
