7700 MultiFrame Manual
7700ACO-HD HD/SD SDI 8 Channel AES & RS-232/RS-422 Auto Changeover
Revision 1.3
Page 19
6.9.1. Adding an Input Signal to the Pool
In order to include an input signal into the pool of monitored signals, the user must add it. The controls to
add
VIDE
and
AES1
to
AES8
, are the same. For the sake of simplicity, only the menu item for
VIDE
is
shown.
POOL
With this control you add the input video signal to the pool of monitored
signals.
NO
– The input video will not be included in the pool of monitored signals.
YES
– The input video will be included in the pool of monitored signals.
VIDE
NO
YES
6.10. SETTING THE TYPE OF AUTO CHANGEOVER MODE
ACOM
This parameter allows the user to set the type of changeover that will occur
if the
MODE
parameter is set to
AUTO
(see section 6.4).
ACO
– The module will be in auto changeover mode where input Bank A
and B are treated equally.
ACOA
– The module will be in auto changeover mode where input Bank A
has priority over Bank B. (i.e. The ACO will switch back to A if A is equal to
B based on POOL settings)
ACD
– The module will be in auto changeover mode based on DVB-ASI
only and where input Bank A and B are treated equally.
ACDA
– The module will be in auto changeover mode based on DVB-ASI
only and where input Bank A has priority over Bank B.
ACO
ACOA
ACD
ACDA