5782DEC
Professional H.264 and MPEG-2 Decoder
WEBEASY
Revision 1.0
Page - 29
Transmit Bandwidth:
When the link is Up, this parameter returns the transmit bandwidth currently
being sent on the Data Port. Reading is in kbps.
Figure 5-3: WebEASY
®
– System Tab continued
Decoder Control
Decoder Reset:
This control is reserved for engineering use.
Decoder Reboot:
This control can be used to soft reboot the device. It will cycle the power relay and
cause an effective power cycle.
Load Factory Configuration:
This control returns all parameters to the original factory default.
Syslog Configuration
Syslog is a valuable tool for debugging the device operation. It is essentially serial readouts over IP,
sent to a dedicated server. If issues are present, Evertz can help install and setup a syslog server for
constant monitoring of the device activity.
External Syslog:
This parameter allows the user to enable or disable sending syslog information to
the configured external server.
System Server IP:
This parameter allows the user to assign the external syslog server IP address.
This will be the address of a PC with the syslog server software installed (e.g. Kiwi Syslog Server)
Temperature
Temperature Monitor:
This displays the temperature of the module.
Configuration Management
Export Configure File:
This parameter allows the user to Export a config file for the entire decoder.
Import Configure File:
This parameter allows the user to Import a config file for the entire decoder.
