5782DEC
Professional H.264 and MPEG-2 Decoder
VLPRO INTERFACE
Revision 1.0
Page - 15
Figure 4-4: VistaLINK
®
– Input Control Tab continued
Switch Over Control
User Redundancy Mode:
This control allows the user to enable or disable redundancy mode on
input.
Active Source:
This monitor displays the active input.
Backup Input Source Select:
This control allows the user to select SFP 1 or SFP 2 as the backup
port.
Backup Input IP Address:
This control allows the user to specify the multicast address to be used
as backup.
Backup Destination UDP Port Number:
This parameter allows the user to select the destination
UDP port number of the backup streaming output.
Backup IGMPv3 Mode:
This control allows the user to select between include and exclude for
IGMPv3 mode.
Backup IGMPv3 SSM Control <1-6>:
This control allows the user to set the IP addresses to be
used while forming the source filter for IGMPv3 communications.
Wait Switch Time after Loss of Primary Input:
This parameter controls the time to wait after
seeing a Primary input loss in seconds. After the timeout, the input will switch to backup.
Wait Switch Time after Loss of Backup Input:
This parameter controls the time to wait after seeing
a Backup input loss in seconds. After the timeout, the input will switch to primary.
Audio Mode
AC3/Dolby E Audio Mode:
This parameter allows the user to set the audio mode to either bypass or
decode the audio stream. When configured to Decode the user can further select if full decode or
