5782DEC
Professional H.264 and MPEG-2 Decoder
GETTING STARTED
Revision 1.0
Page - 3
2.
GETTING STARTED
The 5782DEC module comes with a rear plate that occupies one slot in a frame.
Figure 2-1: 5782DEC-H264HD-IPASI Rear Plate
2.1.
CONNECTIONS
IN 1-2:
BNC connectors used to input ASI MPEG2 Transport Streams.
OUT 1-2:
Two BNC connectors with re-clocked serial component video outputs, compatible
with the SMPTE 259M, SMPTE 292M, and SMPTE 424M (+3G) standards. OUT 2
can be additionally configured for ASI output from IP or the down-converted SD-SDI
output (HDC).
DATA 1-2:
Two SFP cages for streaming Transport Stream data. SFPTR-RJ45-SGM-AV sold
separately.
2.2.
HARDWARE INSTALLATION
To successfully install the 5782DEC, you will require:
1. An unused IP address on the network
2. An Evertz serial cable
3. VLPro Server IP address
Before handling the card it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn. Locate on a frame chassis a vacant slot. Unpack
the 5782DEC and separate the rear panel from the main card. Locate the slot on the rear of the rack
and remove the blanking panel. Insert the rear panel into the back of the chassis and secure using the
two screws provided.
Before inserting the front card, connect the serial cable to the board using the serial cable provided.
Now insert the 5782DEC card into the corresponding front slot ensuring the card lines up with the slot
runners on the bottom and the top of the chassis. Push the card into the slot ensuring that when it
mates with the rear panel is has been firmly pushed into a seated position. This can be confirmed when
the connectivity lights for the Ethernet port are illuminated. Do not connect the HD/SDI Input cable to
the rear card until the initial configuration has been completed (failure to do this could cause unwanted
network issues).
