570NAT-HW-X19
High Density Network Address Translator
Revision 1.0
Page - 25
4.4.1. LAN to WAN: Input Configuration
Flows 1 to 256
Mode:
This control allows the user to enable the associated input stream for encapsulation.
VLAN ID:
This control allows the user to assign a VLAN ID to the associated flow; incoming packets of
the flow with the specified VLAN ID will then be encapsulated.
Input Bit rate:
This monitor will display the bit rate coming in on the port
.
4.4.2. LAN to WAN: Encapsulation Header Configuration
Flows 1 to 256
Source IP Address:
This control allows the user to set the physical source IP address of the incoming
streams.
Source UDP Port:
This control allows the user to set the physical source UDP port of the incoming
streams.
Destination IP Address:
This control is used to configure the output header encapsulation with the
desired destination IP address.
Destination UDP Port:
This control is used to configure the output header encapsulation with the
desired destination UDP Port number.
4.4.3. WAN to LAN: De-Encapsulation Configuration
Flows 1 to 256
Mode:
This control allows the user to enable the associated input stream which is going to be de-
encapsulated.
Input Destination IP Address:
This control allows the user to set the IP address of the packet to be
received for de-encapsulation.
Input Destination UDP Port:
This control allows the user to set the UDP Port number to be received
for de-encapsulation.
Input Bit rate:
This monitor will display the bit rate coming in on the port
.
