570NAT-HW-X19
High Density Network Address Translator
Page - 14
Revision
1.0
Mode of Operation:
Within this drop down menu the user can configure the desired mode of operation
for each core of the 570NAT-HW-X19.
The NAT can be set to:
IP NAT
,
MC-In-MC NAT + IP NAT
,
Port Based NAT
,
VLAN Based NAT.
Once a core has been set to a mode of operation, the settings for the mode of operation on that core
can be set by selecting that core on the WebEASY
®
main menu sidebar (shown in Figure 4-2).
Each mode of operation can be found in the following sections: Port Based NAT [Section 4.3], VLAN
Based NAT [Section 4.4], IP NAT [Section 4.5], MC-in-MC NAT + IP NAT [Section 4.6].
4.1.3. Data Port Traffic Monitoring
For each of the 12 Data ports (6 pairs) the following parameters can be monitored. Port are selected as
WAN-LAN pairs.
Link Speed:
This monitor will automatically detect the link speed of the SFP module installed.
Link Status:
This field displays the physical link status of the associated data port as either
Up
or
Down
.
Received Bandwidth (kbps):
This field displays the bit rate received by the associated data port in
kbps.
Transmit Bandwidth (kbps):
This field returns the bit rate transmitted by the associated data port in
kbps.
Received Healthy Frames:
This parameter displays number of good Ethernet packets received.
Transmitted Healthy Frames
: This parameter displays number of good Ethernet packets transmitted.
Received Corrupted Frames:
This parameter displays number of Ethernet packets received with
errors
Transmitted Corrupted Frames:
This parameter displays number of Ethernet packets transmitted
with errors.
Clear All Statistics
: This control button allows the user to clear all the statistics.
