evertz 570EMR-AG-HUB, User Manual

Page: 17 / 34

570EMR-AG-HUB
User Manual
Revision 0.1
Page - 7
4. HARDWARE INSTALLATION
570EMR-AG-HUB can be installed in one of the following two ways:
1. 570 Frame communication via Frame Controller
2. Standalone 570 Frame (Direct Communication)
Before handling the card, it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap to be worn.
Locate on the chassis two vacant slots. Unpack the 570EMR-AG-HUB and separate the rear panel
from the main card. Locate on the rear of the rack the two slots and remove the blank panels. Insert the
rear panel into the back of the chassis and secure using the screws provided. Now insert the
570EMR-AG-HUB card into the corresponding front slots ensuring the card lines up with the slot
runners on the bottom and the top of the chassis. Push the card
firmly into the slot ensuring that when
it mates with the rear card it has been firmly pushed into a seated position. Do not connect any cables
to the rear card (failure to do this could cause unwanted network issues) until the initial configuration
has been completed. This procedure can be completed to all the other modules and is hot swappable
allowing for the frame to be powered on while installing.