Model 5010 Time Code Master Manual
OPERATING INSTRUCTIONS
Revision 3.1.1
Page 4-37
When the GEVT or REVT register is being displayed, press the
SELECT
key to ‘arm’ the respective
event register for a single event. Press the
SELECT
key again to ‘disarm’ the event register. A lower
case ‘
s
’ will be shown to the left of the hours digits of the display when the register is armed for a single
event. Press the
SHIFT+SELECT
keys to ‘arm’ the respective event register for continuous events.
Press the
SHIFT+SELECT
keys again to ‘disarm’ the event register. A lower case ‘
c
’ will be shown to
the left of the hours digits of the display when the register is armed for continuous events. When the
time code being generated matches the value entered into the GEVT register, the event output will be
activated for the duration set in the GPO DURATION menu. When the time code being read by the
Reader matches the value entered into the REVT register, the event output will be activated for the
duration set in the GPO DURATION menu. When the event register is armed for single event mode,
the output will occur the
first time
the comparison matches. The event must be re-armed for the event
to occur again. When the event register is armed for continuous event mode, the output will occur
each
time the comparison matches.
4.8.7. Adjusting the General Purpose Output Duration
The GPO DURATION menu item on the CONFIGURATION Engineering Setup menu is used to adjust
the duration of the general purpose outputs. Use the
Ï
OR
Ð
keys to change the duration
.
4.8.8. Resetting the 5010 to its Factory Defaults
The
FACTORY RESET
menu item is used to reset the 5010 to the factory default parameters. Press
the
SHIFT + ENTER
keys when the sub-menu screen is displayed to reset the 5010 to factory defaults.
The 5010 will perform a power-on configuration before returning to the normal operating mode.
GPO DURATION
GPO DURATION
LENGTH = 01 FRMS
Ï
Ð
TO ADJUST
FACTORY RESET
** WARNING **
THIS
COMPLETELY
RESETS UNIT
PRESS THE SHIFT
+ ENTER KEYS TO
PROCEED
PRESS THE
SELECT KEY TO
CANCEL
