3505 Frame Manual
3505FR Series Fiber Optic SFP Frame
Page - 38
Revision 1.2
CONFIGURATION AND CONTROL
Figure 5-10: 3405R-2R
VistaLINK
®
RX Configuration Tab
5.2.2.1.
Tx Configuration
•
Laser Status:
Displays the status of the laser in a SFP transmitter module.
•
Wavelength:
Displays the wavelength of the SFP transmitter.
•
Status:
Displays the general health of the SFP.
•
Reclocker:
Displays Reclocking Standard if applicable.
•
Squelch:
Sets Squelch Mode.
5.2.2.2.
Rx Configuration
•
Received Optical Power:
Displays the optical input power of a SFP receiver.
•
Reclocker:
Displays Reclocking Standard if applicable
•
Low Optical Threshold:
Sets Low Optical Threshold value
•
Inversion:
Sets output inversion mode
•
Slew Feature:
Sets output Slew rate mode
•
Squelch:
Sets output squelch mode
•
Swap Channel:
Sets output mapping mode
5.2.3. Faults Tab
The
Faults
tab allows the user to enable a variety of traps. To enable a particular trap, simply click the
box adjacent to each trap so that a check-mark appears. When a check-mark is present, the trap is
enabled. When a check-mark is not present, the trap is disabled.
The
Trap Status
section defines whether a trap is present or missing. If the box is green, then the
corresponding trap is present. If the box is red, then the corresponding trap is missing.
