EverExceed uXcel Series, User Manual

Page: 3 / 26

2
Safety Instructions
1).Avoid electric shock
Danger!!

Please do not touch any part of the battery or the frame, electrolyte, cooling water of
the battery by hand when the equipment charging up the battery. Operator shall wear
insulative waterproof rubber shoes and gloves to operate the battery, or may result in
electric shock injury accident.

Please do not operate the equipment when opening the door of equipment, or may
touch the high voltage terminal and result in electric shock accident.

Keep the equipment off-position when connecting the battery, or may result in electric
shock or injury.

Please do not open the equipment when powering on or operating, or would get an
electric shock.

Please do not approach nearby ground when the equipment is on-position because in
the process of charging, the output positive and negative side would in high pressure
and the ground would have leakage current from the frame. The ground nearby would
in high pressure.

Please do not touch the DC output end in high pressure state, or may result in electric
shock.

When Wiring or examining, power shall be disconnected and 10 minutes later,
detecting the residual voltage disappearing by multimeter, or may result in electric
shock accident.

Please do not maintain the equipment when the DC output end still connecting the
battery even though the power is at a off-position state. Please maintain without
connecting the battery, or may result in electric shock accident for the battery voltage
attaches to the equipment through output cable and the equipment still in high
pressure.

The equipment shall use third-level or above grounding method.

Please do not change the fuse when charging with electricity, or may result in electric
shock.

Please do not change the fuse when the equipment outputting and connecting the
battery.

Please do not operate the switch by wet hand to avoid electric shock.

The operation including wiring and examination shall be conducted by professional
technician.

Please do not damage, stress, clamp or make the input and putout cable carry heavy
objects, or may result in electric shock.

The battery rack or frame shall use third-level or above grounding method.