8
EASY DECISION
LEDS
The LED lamp used in this appliance cannot be replaced by the end user. If there is a fault with the LED lamp, please contact
the Service Department
.
CLEANING
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the rangehood is turned off at the
power point.
Do not use abrasive cleaners to clean the rangehood. The use of warm soapy water and a cloth are recommended.
Ensure that the rangehood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the rangehood must be cleaned regularly to maintain efficiency, and prevent grease build up. It is
recommended that this is undertaken every 4
–
6 weeks, depending on frequency of use.
The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the rangehood must be performed as described above; otherwise there is a possibility of a fire hazard due to
grease and fat build up.
If the rangehood is fitted with charcoal filters (for re-circulating) it is recommended that the filters be changed every 3
–
4
months. Filter replacement will ensure correct function of the rangehood, and ensure that the air being re-circulated back
into the room is clean.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Service Department.
Motor failed
Contact Service Department.
Light does not
work, motor does
not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air ventilation entrance
are not tightly sealed
Take down the one way valve and seal with
sealant.
Leakage from the connection of U-shaped
section and cover
Take U-shaped section down and seal.
Lights not working
Broken/Faulty globes
Contact Service Department.
Insufficient suction
The distance between the range hood and the
gas top is too far
Refit the range hood to the correct distance.
The Range hood
inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
NOTE
: Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service
centre if in any doubt before undertaking any of the above. Always disconnect the appliance from the power source when
opening the appliance.
